Quintech RPS2460QAB000
The Quintech RPS2460QAB000 Series Redundant Power Supply provides a centralized power source for as many as 16 LNAs, LNBs, upconverters, downconverters, and line amplifiers. The unit is comprised of two separately fused power supply modules configured for nominal voltage or +24 VDC @ 6.0 amps and has been designed for international use with an input voltage of 100-240 VAC, 50/60 Hz. The power supply modules are on individual drawers to provide easy replacement of a failed module. Both supplies are monitored by a summary alarm which employs a serial RS-422 interface. On the rear panel, green LEDs indicate power status for each of the input ports. Each input port is capable of supplying up to 900 mA through an automatically resetting circuit breaker. Loads in excess of 900 mA will trip the breaker, shutting down the input port until the current demand drops below the trip point.
DX Antenna DIR-747
The DX Antenna DIR-747 Integrated Receiver/Descrambler features space saving 1 3/4 low profile design, full featured LCD display, microprocessor controlled with non-volatile memory, integrated VCRSฎ descrambling module with OSD, front panel controls including VCRSฎ video level control, front panel video test port, discriminator detector circuit provides unsurpassed performance in T.I. environments, selectable AGC or MGC, contact closure switching system permits alternate transponder and feed selection, and C-band and Ku-band compatible.
MCL MT2300
The MCL MT2300 is an antenna mount traveling wave tube
low power amplifier- The rugged and economical solution
for uplink applications. Features include - Compact Weather-Resistant Package -
Extensive Diagnostic Capability - Designed to Meet MIL-188-164A - Software Communications Configuration for Both Remote and Computer Interfaces -
Continuous Attenuator Adjustment shown in dB -
Auto Power Control and Status -
Rugged Construction for Extreme Environments -
MTBF: 81,000 Hours (Tube)
193,686 Hours (Power Supply)
MCL MT3200A
The MCL MT3200A is a traveling wave tube medium power amplifier for satellite uplink applications which features Reduced Depth -
Output RF Power Hold-
Easily Accessible Diagnostic Port -
Programmable Alarms -
Event And Maintenance Logs -
Ethernet Interface -
Field Replaceable Modules For Unsurpassed
Serviceability
Closed-Loop Forced Air Cooling -
Typical Phase Noise 12 dB Below IESS-308 -
Control Dial For Easy Set-Up And Adjustment
MCL MT4000
The MCL MT4000 traveling wave tube medium power amplifier for satellite uplink applications which features Event Log Screen with Report of Failure -
Level, Date, and Time -
Auto Power Control and Status -
Continuous Attenuator Adjustment in dB -
Filament Off State -
Local, Remote, or Computer Control Modes -
Optional Linearizer Control -
Front Panel RS232 Diagnostic Interface
MCL Redundant Systems
MCL Redundant Systems. Each amplifier in the MCL product line is available in a number of redundant
configurations to accommodate system redundancy or to combine outputs of
multiple amplifiers to increase system output power. Standard configurations include 1:1
Redundant Systems, 1:2 Redundant Systems, Phase Combined Systems,
1:2 Redundant Phase Combined Systems, and Variable Phase Combined
Dual Feed Systems. Other configurations are available upon request.
Microwave Filter 7893D
The Microwave Filter Series 7893D C-Band bandpass filter is installed between a TVRO feedhorn and the LNA or LNB to suppress strong out-ofband interference caused by marine or airport radar systems. Coastal and marine navigational radar frequencies (2.9-3.65 GHz) are just below the TVRO band and frequently wipe-out
transponders 1-5 in TVRO's installed near harbors. The airport altimeter band (4.25-4.40
GHz) will affect channels 22-24 at TVRO sites near airports. The Microwave Filter model 7893D interference filter operates at RF before down conversion. This prevents the generation of undesirable mixer products and receiver "desensitization" due to
strong out of band signals.
Norsat LNB 1000H
The Norsat 1000H Series LNB offers better PLL Stability and Phase Noise in a compact package. The Norsat 1000H Series LNB is
designed to provide commercial quality for VSAT and select digital applications such as:
-Low data rate digital video
-A reference LNB for Receiver test & service
-SCPC digital or analog audio
-Low speed SCPC data from 19.2 kbps - 512 kbps, or any higher data rate
Norsat LNB 3000
The Norsat LNB 3000 Data is Norsats premium quality
C-brand PLL LNB. The preferred LNB for all C-band applications.
The Norsat 3000 series is designed to provide higher performance for VSAT and select digital applications such as:
- Low data rate digital video
- A reference LNB for Rx test and service
- SCPC digital or analog audio applications
- Low speed SCPC data from 19.2 Kbps to
512 Kbps, or any higher data rate
Norsat LNB 4000
The Norsat LNB 4000 Series offers built-in transmitter filter, best DRO stability and Phase Noise in a compact package. The Norsat 4000 series is designed to provide higher performance for VSAT and select digital applications such as:
*Higher data rate digital video or commercial analog
*Some SCPC digital or analog audio applications
*Any SCPC data rate above 1 Mbps
Norsat LNB 8000
The Norsat LNB 8000 Series is designed to provide commercial quality for VSAT and select digital applications.
Quintech LS 2150A
The Quintech LS 2150A Series commercial quality active (zero loss) L-band splitters meet strict level, match, and loss specifications achieved through the use of Quintech's proprietary microstrip and SMT technology.
Quintech LS 2150P
The Quintech LS 2150P Series are passive satellite L-band splitters which permit simple splitting of RF signals. These commercial quality splitters meet strict level, match and loss specifications achieved through the use of Quintech's proprietary microstrip and SMT technology.
Quintech RFS-2150
The Quintech RFS 2150 L-band Redundancy Switch detects the presence of primary RF signal feed and provide the ability to switch to a backup (secondary) signal upon the loss of the primary.
Tekron RSS-2L
The Tekron RSS-2L is designed to monitor both the Vertical & Horizontal polarized LNB feeds (950-1450 MHz) independently and from the same chassis, with automatic switchover to backup LNB feeds.The threshold level at which the unit switches to the backup feed is adjustable and separate for the Vertical and the Horizontal primary feeds.
Quintech SRR-SERIES
The Quintech SRR Series RF Routing Switches & SRX Series Modular (up to 128x1) RF Routing Switches are uni-directional, programmable RF routers that provide RF signal routing capabilities. They are equally suitable for baseband, data, IF, or RF switching environments.
Wegener UNITY 4600
The Wegener Unity 4600 is specifically designed to meet the needs of professional media networks. The Unity 4600 has both analog and digital outputs built in, enabling you to deploy one common IRD to both analog and digital affiliates. The digital output is DVB ASI. The Unity 4600 is equipped with two stereo audio pairs, in both MPEG layer 2 and Dolbyฎ Digital formats.
NOTE: You may need the FREE Adobe Reader
to view this document. If you do not have it installed
on your computer, you can download it here:
goldcoastwebdesign.com